《魔鬼剋星》遊戲問題解決心得

發佈日期 2013-06-03 09:21:00

進入選項設定後卡/慢/ loading時間異常解決辦法

: Using nvidia’s official updated driver (I normally used modded drivers)

2: Updating my vista to SP2

After doing that I was able to play the game on max settings and 1920x1200 resolution no lag XD

Geforce 8800m GTS 512mb

2.4ghz Duo

4gb ram

Vista

ect

翻譯如下:

1.使用Nvidia正式版的驅動程式(作者原本都使用修改版)

2.假如使用的作業系統是Vista,升級到SP2

做了以上調整,他可以非常順暢的在1920x1200的解析度下玩這遊戲不會卡

特殊場景卡/慢/ FPS不穩定解決辦法

原文內容:

I think I just figured out something that might interest some of you having frame rate issues. I have a Nvidia chipset on this particular PC, but ATI should be similar if this problem is also found on ATI cards.

I went into my Nvidia Control panel to try and figure out what’s going on in this game. I saw ran a log in the background and noticed some strange CPU and GPU things going on, so I started looking around in my setting for what might be causing this issue. I know the game uses a lot of breakable objects and some physics, so I figured it was a combination CPU use and a bottleneck on the GPU side with the sync’d to 30hz/60hz

Anyway - Try the following if you are getting jerky frame rates in specific zones.

- Go into you vidcard control panel and see if you can create profiles for each game.

- Create a profile for Ghostbusters

- I turned off Multiple Monitor and put Single only.

- Turn on Triple Buffers to smooth out FPS lock.

** Now here’s the big setting that made the game run MUCH better **

- Look in the main control panel area for PhysX Acceleration. Disable this setting. Sadly, you can’t save per game this setting from the looks of it.

- Start GB and you should notice that the game runs fluid even in the areas where FPS was dropping to single-digits.

Hope this helps you guys out there!

在此翻譯重點解決方法:

開啟Nvidia控制皮膚,假如有使用多個顯示器,請設定只使用單一顯示器

看一下抓鬼特攻隊有沒有在程式設定裡面(Nvidia控制皮膚-->進階設定-->管理3d設定-->程式設定)